Address
Riyadh, Al Hamra District, 7568 Ash Shaikh Hasan Ibn Hussain Ibn Ali Street, Second Floor, App. No. 5.
Call us+9660114556842
EnergyServ performs electrical, mechanical and control systems testing, commissioning and start-up according to the highest standards in energy & and industrial systems.
EnergyServ covers the commissioning and start-up activities in different types of power plants i.e. thermal; simple cycle and combined cycle power plants; including the following systems and equipment:
Gas and Steam turbine electromechanical systems commissioning
Boiler or HRSG electromechanical systems commissioning
Balance of Plant Preparation of commissioning procedures
Water treatment systems commissioning
Electrical and mechanical equipment inspection
Electrical and mechanical equipment pre-commissioning and commissioning
Interfacing, signaling, grounding, wiring continuity and loop check
Protection relays testing and validation
Field instrument calibration and loop check
DCS, SCADA and PLC systems logic and functional testing and validation
Hydro and pneumatic tests
Piping flushing and blowout (air and steam)
Alignment of rotating machines (pumps, fans, etc)
EnergyServ covers the commissioning and start-up activities in Substations for all components up to 500KV (GIS) & outdoor (AIS) Substations; including testing of the following substation main systems and equipment:
Circuit breaker testing (function, timing, contact resistance, contact travel distance)
Power transformer up to 500MVA and 500kV testing (insulation resistance, ratio, vector group, DC winding resistance, tan delta, frequency resonance analysis, oil testing, etc)
Shunt reactors, capacitor banks & auxiliary transformers
Current and potential transformers testing
All components of up to 500KV (GIS) & outdoor (AIS) sub-station
Cables continuity, insulation resistance and HV test as applicable
AC dist. board, DC dist. board, neutral ground NGR. Resist. & ring main units RMU
Relay & control panels, fault and sequence of event recorder
Systems interfacing, stability, scheme, function and overall interlocking
Relay & control panels factory testing, site training and factory training
Grounding system testing
Cables high voltage test up to 33KV
Firefighting and HVAC system
DCS, PLC and SCADA systems